Haltech E6A - Manual (Page 105)

105
Output Function
INJ1 Spare function
INJ2 Fuel (primary)
INJ3 Fuel (secondary)
INJ4 Fuel (secondary)
IGN OUT Leading spark (both)
AUX OUT1 Trailing spark front rotor
AUX OUT2 Trailing spark rear rotor
B.7 Summary Table
The list that follows shows the different types of output configurations that may be employed.
Note that in some cases, an Extra Driver Box is needed to provide sufficient driver power.
“Standard” fuel injection is multipoint, staged or batch fire. DF is for Direct Fire.
# Cyl. Ignition Fuel Aux. Out 1 Aux Out 2
1 Distrib* Any Yes Yes
2 Distrib** Standard Yes Yes
2 Distrib** Sequent. Yes Yes
2 DF - 2 coil Standard No Yes
2 DF - 2 coil Sequent. No Yes
3 Distrib Standard Yes Yes
3 DF Standard No No
3 Distrib Sequent. Yes No
4 Distrib Standard Yes Yes
4 DF - 2 coil Standard No Yes
4 DF - 4 coil M’Point No No
4 Distrib Sequent. No No
5 Distrib Standard Yes Yes
6 Distrib Standard Yes Yes
6 DF Standard No No
6 Distrib Sequent. Yes No
8 Distrib Standard Yes Yes
8 DF Standard No No
8 Distrib Sequent. No No
8 Twin Dist Standard No Yes
10 Distrib Standard Yes Yes
12 Distrib Standard Yes Yes
12 Distrib Sequent. Yes No
12 Twin Dist Standard No Yes
12 Twin Dist Sequent. No No
* Although strictly there is no distributor on a 1 cylinder engine, selecting Direct Fire will
cause the E6A to wait for a Home signal.
** This configuration could also be used for waste-spark direct fire ignition.