Haltech E6A - Manual (Page 12)

12
Haltech E6A Specifications
Engine Suitability
•
up to 16,000 rpm
•
1, 2, 3, 4, 5, 6, 8, 10, 12 cylinders (1-2 rotors)*
•
2 or 4 stroke
•
normally aspirated or supercharged up to 200 kPa (30 psi)
•
load sensing by throttle position or manifold pressure
•
multipoint, batch-fire, staged or sequenced (up to 4 banks) injection patterns
•
distributed ignition systems, or direct fire systems with 1 to 4 coils
NB: Sequential and Direct Fire can not be used together.
Power Requirements
••
Power Source
8.6 to 16 Volts DC
••
Consumption
Haltech ECU: 270 mA at 12 Volts
Injector Load: Dependent on injector type
approx. proportional to injector duty cycle
(typically 0.6 Amps per injector)
Physical Specifications
•
ECU Dimensions
Length: 168 mm (6 5/8")
Width: 145 mm (5 5/8")
Depth: 41 mm (1 5/8")
•
Weight
ECU: 760g (1.68 lb)
Loom: 1.92kg (4.2 lb)
Sensors: 500g(1.1 lb)
Shipping Weight: 4.5kg (9.9 lb)
(Including manual/packaging)
Input Sensors
•
Manifold Absolute Pressure (MAP) Sensor
1 Bar -100kPa to 0kPa (Naturally Aspirated)
2 Bar -100kPa to 100kPa (up to 1 Bar or 15 psi boost)
3 Bar -100kPa to 200kPa (up to 2 Bar or 30 psi boost)
•
Temperature Sensors (Air and Coolant)
NTC temperature dependent resistor type.
Operating Range
Continuous -40°C to 100°C (-40°F to 212°F)
Intermittent up to 125°C (257°F)
•
Throttle Position Sensor
10 k
Ω
rotary potentiometer driven from throttle shaft