Haltech E6A - Manual (Page 29)

29
When it is finished, the installation programme will tell you if the installation is successful. If it
was not, consult the trouble shooting section of this manual.
The E6A Programme is now ready to run.
2.2.3 Running the Software from the Hard Disk.
Boot your computer up as described earlier. If your computer is already on, make sure the C
drive is currently selected. To change to the HALTECH directory type :
cD \haltech¬
or, if you used a different destination directory, type that path.
To start the programme type :
e6a¬
The E6A programme will now run. The next section is on running the software from a floppy
drive. You can skip this section and go straight to the section entitled Azerty Keyboards.
2.2.4 Running the Software from the Floppy Disk.
To run the software from a floppy drive, boot your computer up as described earlier. Insert the
Programming disk in the disk drive. If the drive is the A drive, then it must be currently
selected. To select the A drive (or B drive if it is the required drive) type :
a:¬
or
B:¬
You should now see the prompt :
A:\>_ or B:\>_
To start the E6A program type :
e6a¬
The E6A program will now run.
2.2.5 Azerty Keyboards
Most countries use a keyboard where the first six letter keys across the top row are :
qwerty