HONDA 2007 Accord Coupe - Owner's Manual - Manual (Page 182)

Plug in the garage door opener
motor, then test the HomeLink
button by pushing it for about
1
second.
If the button works ,
programming is compl ete.
If the button does n ot work go
to step 6 .
Press and hold the remote
transmitter button and one o
f the
HomeLink buttons at the same
time.
If the red indicator in Hom eLink
begins to flash slowly at fir st,
then rapidly, release both
buttons, and go to step
5 .
If the red indicator in HomeLink
continues to flash slowly (does
not flash rapidly), your remote
transmitter may stop
transmitting after a short time.
Go to step
4 .
Press and hold the remote
transmitter button and one of the
HomeLink buttons at the same
time. While continuing to hold the
HomeLink button, press and
release the remote transmitter
button every 2 seconds.
If the red indicator in HomeLink
begins to flash slowly at first,
then rapidly, release both
buttons, and go to step
5 .
If the red indicator in HomeLink
continues to flash slowly (does
not begin to flash rapidly),
repeat steps
2 thru 4 .
Repeat these steps to train the
other two HomeLink bu ttons to
operate any other com patible
remotely controlled de vices
around your home (ligh ting,
automatic gate, securi ty system,
etc.).
If the indicator flashes rapidly
for 2 seconds then stays on, you
have a rolling code transmitter:
go to ‘‘Training with a Rolling
Code System’’ (see page ).
If the indicator stays on or
flashes slowly, repeat steps
2
thru 5 .
Push and hold the HomeLink
button for a few seconds, then
watch the red indicator on
HomeLink.
3 .
4 .
5 .
6 .
7 .
180
HomeLink Universal Transceiver
Fe
a
tu
re
s
179
Main Menu Table of Contents s t Main Menu s t Table of Contents