HONDA 2007 Accord Coupe - Owner's Manual - Manual (Page 243)

Check the fluid level with the engine
at normal operating temperature.
Park the vehicle on level ground.
Start the engine let it run until the
radiator fan comes on, then shut
off the engine. For accurate
results, wait about 60 seconds
before going step
2 , but don’t wait
longer than 90 seconds.
Always use Honda ATF-Z1
(automatic transmission fluid). If
it’s not available, you may use a
DEXRON III automatic
transmission fluid as a temporary
replacement. However, continued
use can affect the shift quality.
Have the transmission flushed and
refilled with Honda ATF-Z1 as
soon as it is convenient.
Insert the dipstick all the way back
into the transmission securely as
shown in the illustration.
Make sure the notch fits in the
dipstick guide and the dipstick is
down all the way.
If you are not sure how to add fluid,
contact your dealer.
If the level is below the lower
mark, add fluid into the dipstick
hole to bring it to the level
between the upper and lower
marks.
Remove the dipstick and check
the fluid level. It should be
between the upper and lower
marks.
Insert the dipstick all the way into
the transmission securely as
shown in the illustration.
Make sure the notch in the rubber
cap fits in the dipstick guide and
that you push the dipstick in all
the way.
Pour the fluid slowly and carefully
so you do not spill any. Clean up
any spills immediately; it could
damage components in the engine
compartment.
5 .
4 .
6 .
1 .
3 .
Transmission Fluid
Automatic Transmission
240
DIPSTICK
V6 models
Main Menu Table of Contents s t Main Menu s t Table of Contents