Gauges – HONDA 2007 Accord Coupe - Owner's Manual User Manual

Page 68

Advertising
background image

In certain weather conditions,
temperature readings near freezing
(32°F, 0°C) could mean that ice is
forming on the road surface.

When the temperature reaches the

outside temperature displayed.

NOTE: The temperature must be
stabilized before doing this
procedure.

If the outside temperature is
incorrectly displayed, you can adjust
it

5°F in U.S. models (

3°C in

Canadian models) warmer or cooler.

This indicator displays the outside
temperature in Fahrenheit (U.S.
models) or Centigrade (Canadian
models). To see the outside
temperature, press and release the

temperature is displayed.

The temperature sensor is in the
front bumper. Therefore, the
temperature reading can be affected
by heat reflection from the road
surface, engine heat, and the
exhaust from surrounding traffic.
This can cause an incorrect
temperature reading when your
speed is under

19

mph (30 km/h).

Select the outside temperature
indicator, then press the Select/
Reset knob for 10 seconds. The
following sequence will appear for

1

second each: 0,

1

,

2

,

3

,

4

,

5

,

5

,

4

,

3

,

2

,

1

, 0 (U.S.) or 0,

1

,

2

,

3

,

3

,

2

,

1

, 0 (Canada).

The sensor delays the display update
until it reaches the correct outside
temperature. This may take several
minutes.

If your fuel fill cap is loose or
missing, a ‘‘CHECK FUEL CAP’’
message appears on the information
display after you start the engine.
Turn the engine off, and confirm the
fuel fill cap is installed. If it is, loosen
it, then retighten it until it clicks at
least once. When you restart the
engine, the message appears again.
The message goes off after several
days of normal driving once you
tighten or replace the fuel fill cap. To
scroll to another display, press the

CONTINUED

On

4-

cylinder EX-L, SE, and

Outside Temperature Indicator

Check Fuel Cap Indicator

Gauges

Inst

ru

m

e

nt
s

a

nd

Cont

ro

ls

65

V6 EX models

select/reset knob until the

desired value, release the select/
reset knob. You should see the new

select/reset knob.

Main Menu

Table of Contents

s

t

Main Menu

s

t

Table of Contents

Advertising