IC Realtime 1/2/4 Channel H.264 Network Video Server - Manual (Page 57)

51
Alarm Centre
Alarm centre interface is shown as below. See Figure 5-36.
This interface is for you to develop. The alarm signal can be uploaded to the alarm centre when
there is local alarm.
Please set the corresponding parameters such as server IP, port and etc.
The system can send out the data as the protocol defined to the client-end.
Figure 5-36
Advanced
The advanced interface is shown as in Figure 5-37.
 Multiple cast
Please refer to chapter 4.4.1.2 for detailed multiple cast setup information.
 PPPoE
Please input the PPPoE user name and password you get from the IPS (internet service provider)
and enable PPPoE function. Please save current setup and then reboot the device to get the
setup activated.
Device connects to the internet via PPPoE after reboot. You can get the IP address in the WAN
from the IP address column.
Note:
After PPPoE successful dial, you need to go to the device local end to get device current IP
address and then use the client-end to access this IP address.