IC Realtime 1/2/4 Channel H.264 Network Video Server - Manual (Page 72)

66
Dial activate The mobile user can give a call to activate the device to connect to the 3G
network.
You need to check the box to enable current function.
Caller You can input several senders’’ mobile number here.
Add Click it to add the corresponding mobile phone user.
Delete Click it to remove the corresponding mobile phone user.
Message type
There are two types: SMS and MMS.
Right now system supports SMS only.
Title You can input message subject here.
Event message
save System can save the message receiver number so that device can send
out alarm (motion detect) message to the specified mobile phone(s).
SMS save System can save the mobile phone number which can send out the
message to activate the device.
Before the operation, please make sure you device can connect to the 3G
network and you have enabled the 3G function.
When the specified mobile number sends out the message “on” to the
device, the device begins 3G dial up and then connect to the 3G network.
When the specified mobile number sends out the message “off” to the
device, the device disconnects the network and then becomes offline.
Dial save System can save the mobile phone number which can dial the device to
enable it to connect to the 3G network.
Before the operation, please make sure you device can connect to the 3G
network and you have enabled the 3G function.
When the specified mobile phone number gives a call to the device, the
user can hear device prompt: The user is busy now. Then the device
begins dial up and connects to the 3G network.
Refresh Click this button to get device latest configuration.
5.3.4.5 WIFI
It is to set WIFI wireless network and display corresponding network status information.
Extension Config-WIFI setup interface is shown as below.: