Interlogix KTD-400 - Manual (Page 13)

9
In some applications, you may prefer to number the monitors 1, 2, 3, etc., instead of using the matrix switcher
output number. To allow for the difference in numbers, subtract the desired monitor number from the matrix
switch output number and enter the result as the monitor offset in the menu shown in Figure 18.
For example, if a keypad has a monitor that is connected to matrix switcher output 8, to enable the monitor to
be addressed as monitor 1, subtract 1 from 8 and enter 7 as the monitor offset.
8 (matrix switcher number) - 1 (monitor number) = 7 (offset)
In this example, if more than one monitor were to be controlled from the keypad, additional monitors would be
connected to matrix switcher outputs 9, 10, 11, etc. and would be controlled as monitors 2, 3, 4, etc.
Note: The keypad will deny any monitor offset number that conflicts with the largest monitor (Figure 11 on page 7) and
monitor access (Figure 13 on page 8) programming choices that you made earlier in this section.
After you make an entry in the monitor offset display, the keypad will return to the normal operating display.
9. The menu in Figure 16 lets you select which
VCRs can be can be enabled from the
keypad. This display will only come up if
your system has at least one VCR.
• If you don’t want to enable any VCRs,
press Seq to advance to the maximum
preset display (Figure 17).
• Press 0 to advance to the next VCR, or
use the up and down arrows to move
between VCRs.
• Press 1 to enable a VCR. After setting
values for all VCRs in your system,
press Seq to advance to the next menu.
Figure 16. VCR access display
10. The menu in Figure 17 determines the
maximum number of programmable presets
that can be accessed from the keypad. The
range is from 00 (none) to 63. Press Seq to
advance to the next menu.
Figure 17. Maximum preset display
11. The default program for the keypad indicates
that the selected monitor number will
correspond to the number of the matrix
switcher output to which it is connected. For
example, if monitor 12 appears in the
keypad’s display window and a camera
selection is made, the monitor that is
connected to output 12 of the matrix switcher
will switch to that camera.
Figure 18. Monitor offset display
VCR 01 ACC=YES
0=NO 1=YES SEQ=NEXT
MAX PRESET: 09
(OO FOR NONE) SEQ=NEXT
MONITOR OFFSET
NUMBER? SEQ=NEXT