Interlogix KTD-400 - Manual (Page 14)

KTD-400 Controller Keypad
User Manual
10
System component configuration
After you have completed the KTD-400 keypad configuration, you can used the keypad to configure other
Digiplex system components. To configure these system components, begin at the normal operating display
and do the following:
To configure video switchers, alarm interfaces, and CyberDomes, press the appropriate number at the
component configuration selection menu (Figure 21) and refer to the programming instructions provided with
those products.
To configure PTZ receivers, press 2 at the component configuration selection display (Figure 21) and follow
the instructions in
PTZ receiver configuration on page 11.
1. In the normal operating display shown in
Figure 19, press and hold the Set key until
the display in Figure 20 appears.
Figure 19. Normal operating display
2. In the menu in Figure 20, enter the access
code 9, 5, 1, Seq. The next display will
appear.
Figure 20. Code entry display
3. The component programming selection
menu (Figure 21) lets you select which
component (video switchers, PTZ receivers,
alarm interfaces, and CyberDomes) to
program.
Figure 21. Component configuration selection display
CAMERA 000
MONITOR 01
CAMERA 000 (CODE)
MONITOR 01 (----)
1=SWTCH 2=PTZ 3=ALRM
4=CYBER SEQ=EXIT