Interlogix KTD-400 - Manual (Page 7)

3
Installation
To install a KTD-400 keypad, you will need to set the DIP switches, mount the unit (KTD-300R only), and
wire the device.
DIP switch settings
Use Table 1 to select your mode of operation.
Figure 3 shows how to open the KTD-400 and KTD-300R and locate the DIP switches.
Figure 3. DIP switch locations for KTD-400 and KTD-300R models
CAUTION: Do not connect power to the unit before all installation steps have been completed. Do not connect directly to
a telecommunication network.
Table 1. DIP switch settings
Setting Binary Description
1000 Digiplex PTZ and VCR control only.
0100 Controlling a robot MV96 multiplexer with a KTD-93.
1100 Digiplex PTZ, multiplexer, and VCR control (factory setting).
0000 Controlling a robot MV96 multiplexer with a KTD-93.
KTD-400 KTD-300R
4-position
DIP switch