Interlogix KTD-400 - Manual (Page 23)

19
Multiplexer operation
The Mode key toggles the KTD-400 between normal operation mode, multiplexer operation mode, and VCR
operation mode.
Switching to multiplexer control mode
To enter the multiplexer operation mode, press Mode once and the display shown in Figure 39 appears.
Figure 39. Multiplexer operation mode
The keypad is now able to control multiplexers.
Selecting an active multiplexer
Press Sel followed by the number keys to enter the multiplexer number you want to control. For example, to
select multiplexer number 12, press Sel, 1, 2.
Calling video input on an active multiplexer
Once you have selected the desired multiplexer, use the number keys to enter the video input number. For
example, to call video input number 9 on the active multiplexer, enter 0, 9.
Switching a multiplexer to live video
Press Live to place the active multiplexer in the live video mode.
Placing the multiplexer in the camera sequence mode
Press Run to place the active multiplexer in the video sequence mode.
Viewing VCR output or playback
Press VCR to view the output for the VCR during recording or playback from the VCR during review of the
VCR tapes.
Operating electronic zoom
For multiplexers equipped with zoom capability, the Zoom key will switch the multiplexer to this mode.
While view in this mode, the arrow keys are used to move the zoom area within the image (electronic zoom
may vary according to the model of multiplexer).
MULTIPLEXER 01
VIEW --