Interlogix KTD-405 Series User Manual - Manual (Page 34)

KTD-405/KTD-405A/KTD-405-2D Controller Keypad
User Manual
30
In some applications, you might prefer to have the monitors numbered as 1, 2, 3, etc., instead of using
the matrix switcher output number. To do this, subtract the desired monitor number from the matrix
switcher output number and enter the difference as the monitor offset.
For example, suppose a keypad has a monitor that is connected to matrix switcher output 12. To enable
the monitor to be addressed as monitor 1, subtract 1 from 12 and enter the difference (11) as the
monitor offset.
In this example, if more than one monitor were to be controlled from the keypad, additional monitors
would be connected to matrix switcher outputs 13, 14, 15, etc., and would be controlled as monitor 2,
monitor 3, monitor 4, etc.
Note: The keypad will deny any monitor offset number that conflicts with the monitor system size and the monitor access
programming choices that have been made.
When a spot monitor number is assigned, pressing the 1st key displays the first site number in the
annunciation queue on the spot monitor, and the keypad automatically addresses control to that
monitor.
12. By default, the selected monitor number
corresponds to the number of the matrix
switcher output to which it is connected. For
example, if monitor 12 appears in the
keypad’s display window and a camera
selection is made, the monitor that is
connected to output 12 of the matrix switcher
switches to that camera.
Figure 36. MONITOR OFFSET display
13. These menus are used to configure
annunciation. When annunciation is
enabled, the keypad displays the first,
second, and third, call-in queue on the LCD
and can store up to 32 call-in requests.
14. Pressing + and then displays the following
menu (Figure 37).
15. In the annunciation mode, the keypad
produces a tone on a call-in request or alarm.
This sound can be set to one frequency
(single) or to warble between two
frequencies (multiple).
Figure 37. ANNUNCIATION displays
MONITOR OFFSET
NUMBER: 0 NEXT
ANNUNCIATION?
NO
CALL TONE TYPE?
MULTIPLE
SPOT MONITOR
NUMBER: 0