Interlogix KTD-405 Series User Manual - Manual (Page 48)

KTD-405/KTD-405A/KTD-405-2D Controller Keypad
User Manual
44
Setting autopan limits
You can set the left and right autopan limits separately.
Left autopan limit
To set the limit for the left turn-around point of the camera’s back and forth motion, as wells as the tilt and
zoom positions for the autopan, do the following:
1. Position the camera at the desired left limit.
2. Tilt and zoom the camera into the desired position.
3. Press store.
Note: Do not attempt to enter a preset number. The preset number 62 is reserved for the left autopan limit and is
automatically entered when you perform step 5.
4. Press .
5. Press store again. The Store Preset Number displays on the keypad.
Right autopan limit
To set the limit for the right turn-around point of the camera’s back and forth motion, do the following:
1. Position the camera at the desired right limit and press store.
Note: Do not attempt to enter a preset number. The preset number 63 is reserved for the right autopan limit and is
automatically entered when you perform step 3.
2. Press .
3. Press store again. The Store Preset Number displays on the keypad.
Controlling a DVMRe/multiplexer (hybrid mode)
When you press the zone key, the keypad switches to the hybrid zone mode. In this mode, the keypad can
control a DVMRe/multiplexer. Key functions are the same as those used during normal zone mode operation,
except the esc key, which returns the keypad to the standard Digiplex mode. See Table 4. The keypad can
control DVMRe recorders with addresses up to 250. All units with addresses above 32 must have the same
characteristics and permissions as unit 32.
Note: Camera control (PTZ) is disabled while in the hybrid zone mode.