Interlogix KTD-405 Series User Manual - Manual (Page 52)

KTD-405/KTD-405A/KTD-405-2D Controller Keypad
User Manual
48
Zone mode
The LCD displays the zone number and title on the top line and the current camera and monitor numbers on the
bottom line (Figure 61).
Figure 61. Zone mode main menu
To select a zone, press zone and enter the zone number.
The LCD displays the zone number and title, which is created during programming.
Selecting a camera
Use one of the following methods to enter the camera number to select a new camera.
• Enter the camera number including any preceding zeros. (For example, if you have tens of cameras,
enter 01 for camera 1; if you have hundreds of cameras, enter 001 for camera 1.)
• Enter the camera number directly (omitting preceding zeros), then press .
Controlling a camera
The control address of a PTZ camera in zone mode is offset from the number used to select it. When setting up
and controlling your cameras in zone mode, refer to
Receiver site addressing on page 65 in Appendix A.
PTZ. Pan, tilt, and zoom are controlled by the joystick. Zoom is also controlled by the + zoom - key.
To pan, move the joystick left or right. To tilt, move the joystick up or down. To zoom, twist the joystick
knob clockwise or counterclockwise.
Focus. For autofocus, press the autofocus key. To focus manually, use the + focus - key.
Iris. The iris is controlled by the + iris - key; + opens the iris, - closes the iris.
Note: Refer to the CyberDome manual for additional operation on some CyberDome models.
Selecting a monitor
1. Press the mon key.
2. Enter the monitor number including any preceding zeros or enter the monitor number directly and
press enter.
ZONE --ZONE TITLE
CAMERA --MONITOR