Interlogix KTD-405 Series User Manual - Manual (Page 47)

Chapter 4
Operation
43
user would realize the error. The keypad will prompt for the final store press, and give a confirmation message
that it was actually stored. If the preset number is not in the allowed range, the keypad will give an error
message instead of asking for the final press of the store key.
Shortcuts
There are two types of shortcuts provided by the keypad for setting and recalling presets. They are useful for
preset that may be changed or recalled frequently. Presets 58 through 61 are asscesible using the aux keys (aux
1 to aux 4) instead of typing the number. Preset 58 is associated with aux 1, preset 59 with aux 2, and so on.
To recall preset 60, for example, press find and then aux 3. To store preset 60 the press store, aux 3, and then
store again. Except in one case, these preset shortcuts are always available, even if the Preset Limit is set to a
value above the associated preset number. If the supervisor has set the Preset Limit to the value of 128, no
presets at all can be set from the keypad, even the ones that govern the autopan limits.
There is one other, even quicker shortcut. The value of the Preset Limit setting itself defines a shortcut preset
that can be accessed with only the store or find keys. For example, if the Preset Limit is set to 35, to store a
position in preset 35, press the store key three times. In effect, the second press substitutes for typing the preset
number. The preset defined by the Preset Limit can be recalled by pressing the find key twice. If the Preset
Limit is set to a value above the maximum number of presets (set in the user menu) this shortcut is not
available.
Recalling a preset
To recall a preset, do the following:
1. Press find.
2. Enter the preset number using the number keys, or aux, 1, 2, 3, or 4 for presets 58 through 61.
Operating group switching on Digiplex IV switchers
To operate a group, do the following:
1. In Digiplex mode, hold esc and press zone to
display the ENTER MONITOR GROUP
menu (Figure 56).
Figure 56. Enter monitor group menu
2. Enter a number from 1 through 64 that calls
up that group of cameras, or press tour to
display the ENTER GROUP SEQUENCE
menu (Figure 57).
3. Enter a number from 1 through 12 initiates
that group sequence.
Figure 57. Enter group sequence menu
ENTER MONITOR GROUP
(1-64)_ _OR <TOUR>
ENTER GROUP
SEQUENCE