Casio IT-2000D - Manual (Page 121)

121
How to create a card for installation :

Make an appropriate directory on the ATA card and copy the application program, files
that are used by this application program, CONFIG.SYS, and AUTOEXEC.BAT onto
this directory.

Create CONFIG.SYS and AUTOEXEC.BAT for card boot. At the end of
AUTOEXEC.BAT add a line for copying the above mentioned directory wholly onto the
user disk.

The above steps complete the creation of a card for installation.
Installation work :

In the slot, insert the ATA card that has been created for installation and lock the card
lock switch. If the terminal power is currently on, turn it off. Then press the RESET
button to initiate the System Menu. Turn the Power switch to OFF and then to ON.
The card boot process will take place.

If the batch files called from AUTOEXEC.BAT have been successfully executed,
installation of the application has been completed.

Installation from a PC
This method is used to directly transfer the appropriate files from the PC to the IT-2000 using the
serial cable or I/O Box. For information about this method of file transfer from the PC refer to
Chapter 3.10 " YMODEM Utility", or Chapter 3.11 "FLINK Command".

Copying application program onto another IT-2000
This method is used to mirror-copy the entire contents of the F-ROM drive of one IT-2000 to
another IT-2000. If an application has been installed on one IT-2000 the application can be
installed on another IT-2000. No accessories, such as a card or cable, are required.
For more information refer to Chapter 3.11 "FLINK Command".