Casio IT-2000D - Manual (Page 73)

73
3.14 RAM Disk Size Change
Function
This screen is used to set the RAM DISK size (capacity). The setting will become valid after the
system has rebooted.
Fig. 3.17
Operation
Setting up the RAM disk

Adjust the RAM disk size with the “8” and “2” keys.

Confirm the setup with the “ RET” key.

When the "Hit Any Key... " message is displayed, press any key other than the “Fn” key.

The IT-2000 is turned off. After making sure that it turns off, press the reset switch to turn on
the main unit again.

After the IT-2000 is turned on again, the format confirmation screen, as shown below, will be
displayed during system start-up. Then press the “1” key. This properly formats the RAM disk.
After formatting the RAM disk is usable.
Key Operation Function
8 key Increases the RAM disk size.
2 key Decreases the RAM disk size.
RET key Confirms the currently selected RAM disk size and exits this
operation.
CLR key Cancels the currently selected RAM disk size.
RamDisk is broken.
Format? YES:1/NO:0