CMC electronic MAI085MB - Manual (Page 17)

mAI085-MB Actuator Interface Technical Manual /13
Distributive Intelligence
 CMC INDUSTRIAL ELECTRONICS LTD
Step Function Action at Interface Action at
Actuator Controller
9 From the Main Menu perform a Snd
function to send the previously saved
parameters to the remaining controllers. no action Parameters for all
active actuator
controllers on the
network are
overwritten with
values from the
Interface
10. From the Controller Menu, set the iD
for each of the remaining controllers. ID parameter is
overwritten for each
actuator no action
11 Using the Controller Menu, Calibrate
each of the remaining controllers using
the CAL function. no action Calibration
parameters are
adjusted by the
actuator controller
12 From the Main Menu perform a GEt
function to retrieve the calibrated
parameters from all of the connected
actuator controllers. Interface parameters
are overwritten with the
values from all active
actuator controllers no action
13 From the Main Menu, save the
parameters using the SAv command Parameters are saved
to non-volatile memory no action
Once you have completed this sequence, all of the actuator controllers will be calibrated and
their parameters saved in the Interface’s non-volatile memory. This allows an actuator
controller to be replaced and reconfigured with the parameter values saved in the Interface by
using the Snd command from the Controller Menu.