Vertical Communications 8024S - Manual (Page 66)

Default Volume Control
When you change and save the volume, that change remains in effect until you
change it again (referred to as default setting).
· Set the speaker, headset, handset, or
group listening loudness for all future
calls using the following steps:
1. PRESS
INTERCOM.
2. CHOOSE speaker, headset, handset, or
group listen mode to be affected.
3. While in that mode, PRESS
VOLUME UP
or
VOLUME DOWN to adjust loudness.
4. DIAL
**5
to hold the loudness at
the last setting for all future calls (until it
is changed again).
5. REPEAT this procedure in each mode until all default volume
levels have been properly set.
NOTE: You may adjust the volume of a call in any mode (over speaker, headset,
handset or group listen), at any time during the call, by pressing
VOLUME UP or
VOLUME DOWN. When the call ends, the volume of all future calls is reset to the
programmed (default) setting.
58 LCD Speakerphone Station User’s Guide
Other Features GCA70-281
Impact SCS Volume Buttons
Impact Volume Buttons