Connections, Video system, En gli sh – COBY electronic 5.1 Channel Home Theater DVD System DVD938 User Manual
Page 17
Page 16
Coby Electronics Corporation
www.cobyusa.com
Page 17
En
gli
sh
Connections
Video System
Choose the best available video connection. Avoid using more than
one connection at the same time to prevent signal interference. The
video settings of the unit must match the video connection used. Press
V-MODE on the remote to change the video setting, or change the
video settings in the System Setup menu (please refer to the System
Setup section of this manual for more information).
1 VIDEO SYSTEM CONNECTION
Connections
The following video outputs are available for this unit .
1.1 Composite Video
Use the yellow plug of an AV cable to connect the composite video output of
this unit to the video input of a TV/monitor.
Use a 3-core AV cable to connect the component outputs of this unit to the
corresponding inputs of a TV/monitor.
1. 2 Component Video
-6-
Notes:
Don’t make all the connections above at one time, otherwise the produced pictures
will be affected.
Only when the video settings conform to the actual video system connections does the
player produce the corresponding video output. (Please refer to the
Video Setup in
System Setup chapter).
DVD Player Video Output
Component Video Input
Y
Cb/Pb
Cr/Pr
Y
Cb/Pb Cr/Pr
Component Video Output
VIDEO
Composite Video Output