COBY electronic 5.1 Channel Home Theater DVD System DVD938 - Manual (Page 18)

Page 18 Coby Electronics Corporation
En
gli
sh
www.cobyusa.com Page 19
Composite Video Out (Standard)
Using the supplied AV cable:
Connect one end of the yellow cable to the yellow Video Out jack of 1.
the unit.
Connect the other end of the yellow cable to the yellow Video In
2.
jack of a TV.
Press <V-MODE> on the remote until you see “CVBS” on the TV
screen to set the unit to the composite video mode.
The maximum output resolution for the composite video con-
nection is 480i.
Component Video Out (Best)
Using an optional component video cable:
Connect one end of the green, blue and red cables to the Y, Cb/Pb, 1.
and Cr/Pr Component Video Out jacks of the unit, respectively.
Connect the other end of the green, blue and red cables to the Y,
2.
Cb/Pb, and Cr/Pr Component Video In jacks of a TV, respectively.
You must set the unit’s video output to either YUV or P-YUV when
using the component video output. Use YUV for 480i output; use
P-YUV for 480p output. See the Setup section of this manual for
more information.
You may also press <V-MODE> on the remote until you see
“YUV” or “P-YUV” on the TV screen to set the unit to the compo-
nent video mode.
The maximum output resolution for the component video con-
nection is 480p.
Connections