KERN & SOHN SFB 300K-1LM - Manual (Page 15)

SFB-BA-e-1324 15
6 Unpacking and implantation
6.1 Installation Site, Location of Use
The balances are designed in a way that reliable weighing results are achieved in
common conditions of use.
You will work accurately and fast, if you select the right location for your balance.
On the installation site observe the following:
Place the balance on a firm, level surface;
Avoid extreme heat as well as temperature fluctuation caused by installing
next to a radiator or in the direct sunlight;
Protect the balance against direct draughts due to open windows and doors;
Avoid jarring during weighing;
Protect the balance against high humidity, vapors and dust;
Do not expose the balance to strong humidity for extended periods. Non-
permitted condensation (condensation of air humidity on the appliance) may
occur if a cold appliance is taken to a considerably warmer environment. In
this case, acclimatize the disconnected appliance for ca. 2 hours at room
temperature.
Avoid static charge of goods to be weighed or weighing container.
Being of protection type IP 67 as per DIN EN 60529, the weighing scale is
suitable for short-term use in wet conditions.
Major display deviations (incorrect weighing results) may be experienced should
electromagnetic fields (e.g. due to mobile phones or radio equipment), static
electricity accumulations or instable power supply occur. Change location or remove
source of interference.
6.2 Unpacking/implantation
Scope of delivery / serial accessories:
Balance, see chap. 2
Transit Securing
Mains adapter
Rechargeable battery
Instruction Manual
Carefully remove the balance from the packaging, remove plastic cover, assemble
the tripod and the display unit (see chap. 6.2.1) and setup balance at the intended
workstation.