KERN & SOHN KDE-T - Manual (Page 46)

KDE-T-BA_IA-e-1210 46
„bASUnt“ is displayed. This is where you can set the required
weighing unit.

Press to change between the individual units and
press to select the required unit (ex. here:
„kg“).

(example)
(example)
“SCL.CAP 1”will appear briefly.

Setting first range
A numeric value appears and the digit on the right is
flashing.

Press to increase the numeric value or to
decrease. Press to change to a different decimal
place.
Set weighing scale capacity (here is an example of 50 kg)
and press to confirm.

(example)
“rESOLE 1”will appear briefly followed by a numeric value.

Set readability for first range. You can select between
default values that are dependent on the max load of the
weighing scale.

Press to change between values.

Press to confirm the required value.
“rESOLE 2”will appear briefly followed by a numeric value. As
above, enter required readability and press to confirm
the required value.

“F” will appear briefly before the weighing scale changes to
adjusting mode and “CAL” will be displayed.

Linearizing a weighing scale (see chap 6.7.1)