LAARS IGE-199C - Installation Manual - Manual (Page 29)

LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
A. This appliance does not have a pilot.
It is equipped with a direct ignition
device, which automatically lights
the burner. Do not try to light the
burner by hand.
C. Use only your hand to operate the remote
control keypad. Never use tools. If the
remote keypad doesn’t work, do not try to
repair it, call a qualified service technician.
Forced or improper repair may result in a fire
or explosion.
B. BEFORE OPERATING: Smell all
around the appliance area for gas.
Be sure to smell next to the floor
because some gas is heavier than
air and will settle on the floor.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified
service technician to inspect the appliance
and to replace any part of the control system
and any gas control, which has been under
water.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call the fire
department.
OPERATING INSTRUCTIONS
1. STOP! Read the safety information
above before proceeding.
6. Wait (5) minutes to clear out any gas. If you
then smell gas, STOP! Follow “B” in the safety
information above on this label. If you don’t smell
gas, go to next step.
2. Set the thermostat to the lowest
setting.
7. Turn the manual valve located at the gas inlet of
appliance counterclockwise to “ON” (see
Figure 9).
3. Turn off all power to the electrical
appliance.
8. Turn on all electric power to the appliance.
4. This appliance does not have a pilot.
It is equipped with a direct ignition
device, which automatically lights
the burner. Do not try to light the
burner by hand.
9. Set the thermostat to desired setting.
10. If the appliance will not operate, Follow the
instructions “To Turn Off Gas To Appliance” and
call your service technician or gas supplier.
5. Turn the manual valve located at the
gas inlet of the appliance clockwise
to “OFF” (see Figure 9).
TO TURN OFF GAS TO THE APPLIANCE
1. Set the thermostat to the lowest
setting.
3. Turn the manual valve at gas inlet of appliance
clockwise to “OFF” (see Figure 9).
2. Turn off all electric power to the
appliance if service is to be
performed.
Manual Gas Valve (Fig 9)
29