Cabletron Systems SEH-34 - Manual (Page 31)

INSTALLATION
Page 3-1
CHAPTER 3
INSTALLATION
This chapter outlines the procedure for installing your SEH and
connecting it to a network. You can install the SEH as a stackable or
stand-alone device. Ensure that your network meets the guidelines
and requirements outlined in Chapter 2, Installation
Requirements/Specifications, before installing the SEH.
3.1 UNPACKING THE SEH
Unpack the SEH as follows:
1. Remove the shipping material covering the SEH in the shipping
box.
2. Carefully remove the SEH from the shipping box.
3. Remove the SEH from the protective plastic bag and set it aside to
prevent damage.
4. Visually inspect the SEH. If there are any signs of damage, contact
Cabletron Systems Technical Support immediately.
3.2 INSTALLING THE SEH
You can install the SEH to your network as a stackable or stand-alone
hub. If you want to install the SEH on a wall or a 19-inch rack,
Cabletron Systems offers an accessory kit that includes Rack Mount
Brackets, Wall Mount Brackets, Mounting Screws, and a Strain Relief
Bracket. The accessory kit is not included with the SEH, but you can
purchase it separately from Cabletron Systems as Part Number
SEH-ACCY-KIT.