Cabletron Systems SEH-34 - Manual (Page 35)

INSTALLATION
Page 3-5
3.2.3 Rack Mounting the SEH
Refer to Figure 3-4 and perform these steps to install the SEH in a
19-inch rack.
1. Remove four cover screws (two from each side) located along the
front edges of each side of the SEH.
2. Using the four cover screws removed in step 1, attach the rack
mounting brackets to each end of the SEH.
Figure 3-4. Installing the Rack Mount Brackets
3. With the mounting brackets installed, position the SEH between
the vertical frame members of the 19-inch rack and fasten it
securely with the mounting screws as shown in Figure 3-5.
Figure 3-5. Installing the SEH in the Rack
Screws (4)
Rack Mounting
Brackets (2)
HubSTACK 10BASE-T HUB WITH LANVIEW®
SEH-24
Screws (4)
19-Inch Rack
HubSTACK 10BASE-T HUB WITH LANVIEW®
SEH-24