Cabletron Systems SEH-34 - Manual (Page 36)

INSTALLATION
Page 3-6
3.2.4 Wall Mounting the SEH
When you wall mount the SEH, the cable connections must face down.
Refer to Figure 3-6 and perform the following steps to wall mount the
SEH.
Note: 1/4-inch Molly screw anchors for wall mounting are not
included with the SEH-ACCY-KIT package.
1. Use the supplied screws to attach the wall mounting brackets to
the bottom of the SEH as shown in Figure 3-6. There are two
brackets, one for each side.
Figure 3-6. Installing the Wall Mounting Brackets
2. Select the wall location for the SEH within 7 feet of a power outlet.
Warning: There is a potential SHOCK HAZARD if there is electrical
wiring within the wall that interferes with drilling for pilot holes. Select
a wall location where drilling pilot holes for the Molly screws will not
come in contact with electrical wiring in the wall.
Molly Screws
Wall Mounting Bracket
Molly Screw
Anchors
Bracket Screws