Crisp Solutions UCommand-525 - Manual (Page 17)

— Operating the UC-525
13
Press the button for the device
you wish to program.
You can now start mapping
your device’s remote control
buttons to the UC-525 LCD
buttons.
The power button is the first
button to be mapped.
While pointing your device’s
remote control at the UC-525
learning eye, press the de-
vice’s power button.
Note: The hard buttons don’t
have corresponding symbols
that flash to indicate that they
are ready for learning. Thus
press the hard button you
wish to program and then the
corresponding button on the
original remote control.
First,
uTouch the hard button you
wish to program on the UC-
525 and then press the cor-
responding button of your
devices remote; you will
hear a beep and see the OK
icon. Release the remote
control button of your de-
vice. Press the next hard
button until you have pro-
grammed all hard buttons.
vTouch the upper left button
on the screen and press the
corresponding button of
your device’s remote con-
trol.
UC-525
UC-525