Chief Manufacturing Electric Ceiling Lift SL-236 - Manual (Page 13)

Instruction Manual SMART-LIFT 236 Electric Ceiling Lifts
1 2
INSTALL THE PROJECTOR ON THE LIFT
CAUTION: Improper projector weight distribution could lead to
equipment damage. Make certain projector weight is centered
on cradle when mounted.
1. Install the SLB bracket on the projector (see the SLB manual
for details).
2. Remove the yaw adjustment bracket from the lift (see
Figure 9).
3. Place the yaw adjustment bracket over the studs on the SLB as
shown, selecting the set of holes that best centers the weight of
the projector.
4. Install tapered thumb nuts (minimum 3), making sure the
tapered end is toward the projector.
5. Reinstall the yaw adjustment bracket with projector attached.
NOTE: If desired, the projector can be set directly on the bottom
plate of the lift, not secured by the bracket. The bracket may be
removed for esthetic purpose by removing four roll/height
adjustment nuts (see ADJUSTMENTS).
Install and Route Cables
CAUTION: Do not attach cables to lower lifting arms or sides of
cradle. This may result in damage when lift retracts.
NOTE: Two routing paths are provided, one on each side, to sepa-
rate electrical and video cables.
1. Lower lift to service position.
2. Route and secure all electrical and video cables using ties and
eyelets provided (see Figure 10), leaving some slack between
securing points.
3. Plug the projector’s power cord into one of the two outlets
inside the lift. One outlet is switched and the other is continu-
ously live. The switched outlet is marked with an “S”.
Figure 9. Install Projector
Figure 10. Cable Routing Example