MF Digital DVD-QuadraPRO (Rev: 08/01/02) - Manual (Page 42)

CD-3706/P Operator’s Guide
Document Revision: 030501.1 DVD-QuadraPRO LX Operator’s Guide
Document Revision: 070102
Page 41
Installing the Printer
Included in the Printer option kit are two brackets that allow the printer to be attached to
the QuadraPRO. One bracket attaches to the bottom of the printer, while the other
attaches to the top of the vertical drive bays. Locate the two brackets depicted below:
Attaching Support Bracket to the QuadraPRO
• Place the bracket, picture to the left labeled “Attaches to Drive Bay”, on
top of the drive bay such that the bends are facing down and the thumb-
screws are facing to the right and rear (when viewed from the front).
• Align the countersunk holes with the four holes on the top of the drive
bay.
• Attach the bracket using the four short countersunk screws supplied.