Canon 1650 - Manual (Page 46)

Print Server Management and Configuration AXIS 1650 User’s Manual 46
DHCP Enabled
Select the appropriate radio button to enable DHCP (Dynamic Host Configuration Protocol).
DHCP automatically downloads the IP address to each print server at startup. Depending on how
your network has been configured, other Internet-related parameters such as the default router,
subnet mask, etc. might also be set automatically. It is recommended that you verify the
settings when the server has been restarted and then enter any missing parameters manually.
Default value = No (disabled)
BOOTP Enabled
Select the appropriate radio button to enable BOOTP (BOOTstrap Protocol). BOOTP downloads
the IP address to each print server at startup. Depending on how your network has been
configured, other Internet-related parameters such as the default router, subnet mask, etc.
might also be set automatically. However, we recommend that you verify the settings when the
server has been restarted and then enter any missing parameters manually.
Default value = No (disabled)
RARP Enabled
Select the appropriate radio button to enable RARP (Reverse Address Resolution Protocol). RARP
downloads the IP address to each print server at startup.This method only operates over single
network segments. Other Internet-related parameters such as the default router, subnet mask,
etc. must be entered manually as RARP only sets the IP address.
Default value = No (disabled)
IP Address
Specify the IP address for your print server in the format w.x.y.z. You should acquire a unique
and unused IP address from your Network Administrator in order to prevent conflicts with other
network devices.
Default value = 192.168.0.90
Notes:
• If DHCP, BOOTP or RARP is enabled, your manual settings might be overridden when you
perform a restart. To make sure that this will not happen, you are advised to disable BOOTP
and RARP when you are setting the IP address manually, DHCP is disabled by default.
• Important! If you change the IP address you will lose contact with the print server. You
must enter the new IP address of the print server in the location field of your Web browser
to continue to configure and manage the print server via the Web browser.