Solvline SG-1160 - Manual (Page 30)

SerialGate User Guide
30
Menu Default Descriptions
Socket Port operation mode makes use of this port for awaiting network socket
connections.
Port Alias Port1 Name each port for convenience. 16 Characters at maximum.
Baud Rate 9600 bps
Set communication speed
(Options: 150, 300, 600, 1200, 2400, 4800, 9600, 19200, 38400,
57600, 115200, 230400, 460800, 921600 bps)
Data Bits 8
Set the number of bits in each character size.
(Options: 5, 6, 7, 8)
Stop Bits 1
Set the number of stop bits.
(Options: 1, 2)
Parity None
Set parity bit check scheme.
(Options: None, Odd, Even)
Flow
Control
None
Set the flow control scheme.
(Options: None, Xon/Xoff, RTS/CTS)
Device Type DataOnly
Set the signal line checking method for the device to be connected to
the given serial port.
If the mode is set to Data Only, TxD, RxD, and GND signal lines are
used in inter-device communication.
If the mode is set to Modem Signals, all modem signals except RI
(Ring Indicator) are asserted, tested, and used in communication.
(Options: Data Only, Modem Signals)
Remote IP
Address /
Port
0.0.0.0 /
4000
If the Operation Mode is in TCP Client or UDP Client or Pair_Master
mode, set the IP address and the socket number to connect to.
Keepalive
Check
Time
0
After a certain amount of time passes without any communication
after the socket connection between the given serial port and the
server is established, automatically disconnect the socket
connection. Valid from 0 to 32767 sec.
For example, if the operation mode is set to TCP Server and Alive
Check Time is configured to 10, TCP Server will listen for the client ’s
connection and eventually establish a connection. Since the check
time is 10 seconds, the server will wait for 10 seconds until the client
connected to it sends any packet. If there is no data for 10 seconds,