Sonics FM User Manual

Page 12

Advertising
background image

CABLE CONNECTIONS:

Located at the rear of the power supply are the cable connections as

illustrated below. (The interconnecting cables will be supplied with your

system.)

1. J1, a round, 12-pin RF cable that connects the welding press or converter

to the power supply.

2. J2, an actuation cable that connects the power supply to a trigger source

(refer to wiring diagrams in Appendix).

3. The power line cord that plugs into the appropriate electrical outlet.

Once these connections have been made, the power supply is ready for

operation. If applicable, be sure to consult your welding press instruction

manual to insure that all connections on the press side are correct, and that

the press is ready for operation.

Also located at the rear of the power supply are the following:

4. J3 Printer Output

5. fuse (based on requirements listed in “Power Specifications” table, p. 9),

6. J6 Rotary Table Output (see wiring diagrams in Appendix),

7. J7 I/O (see wiring diagrams in Appendix),

8. J8 I/O(see wiring diagrams in Appendix),

9. J9 Reject Output

10. fuse (based on requirements listed in “Power Specifications” table, p. 9),

11. fuse (fixed 0.5 amp),

12. fuse, not optional (based on requirements listed in “Power Specifications”

table, p. 9)

11

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

I N S T R U C T I O N M A N U A L • M O D E L F M P O W E R S U P P LY

11

NOTE: Detailed wiring

diagrams are supplied

in the Appendix at the

back of this manual.

12

Fan

NOTE: To see a list of

converters that can be

connected to the power

supply, see the table on

the following page.

Advertising