Sonics FM - Manual (Page 39)

REJECT PRINTOUTS
The reason for a reject, such as ± LIM or T5, will be printed out for each weld.
If the Timer 5 limit is exceeded, then the printout will read as follows:
For the example above, the printout indicates that this cycle was rejected
because the Timer 5 setting (0.40 sec.) was exceeded. In this case, the red
LED’s in the corners of both the +LIM and -Lim keys will be illuminated.
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
38
I N S T R U C T I O N M A N U A L • M O D E L F M P O W E R S U P P LY
25 76/o 176.6 ws 0.40 sec. **** Reject T5