TC-Helicon VoiceLive 2 User manual - Manual (Page 15)

15
Step 2: Inputs
First, connect the XLR cable from your microphone to
the MIC input jack on VoiceLive 2.
Next, connect the instrument or device you will use to
control harmony. On power-up, VoiceLive 2 will
automatically configure all harmony presets to recognize
which instrument is connected. Only one of the following
should be connected for this Quick Start.
o Guitar. Connect the 1/4” cable directly from your
guitar (no pedals between the guitar and VoiceLive
2) to the input jack labelled GUITAR IN. If you
want your guitar to go through pedals and an amp,
connect another 1/4” cable from the GUITAR
THRU to either your first effect pedal or your
amplifier.
o MIDI keyboard. Connect a MIDI cable to VoiceLive
2’s MIDI IN from your keyboard’s MIDI OUT. Set
your keyboard’s MIDI OUT channel to channel #1
if it is not already.
o MP3 player (AUX Input). Connect the output of an
MP3 player or another music source to the AUX
input using a stereo 1/8” connector.
If you do not connect an instrument to the GUITAR IN,
MIDI IN or AUX input, most of the harmony presets in
VoiceLive 2 will default to global Scale mode in the Key
of A Major (for this, see the section entitled VoiceLive 2
for the Lead Singer)
Quick Start