TC-Helicon VoiceLive 2 User manual - Manual (Page 70)

V1 to V4 VOICING
The voicing alternatives change in SCALE mode and
they are displayed in scale degree terminology.They are
organized lowest to highest, relative to the input note.
MAP IN SOURCE / MAP IN NOTE
These allow to customize individual harmony note
intervals relative to your input note and create a custom
scale.A custom scale is not share-able with other presets
until the preset is copied to another location.
To customize a scale, pick a key and scale closest to what
you want for your song. Sing the note you upon which
you want the harmony interval to change (MAP IN
SOURCE set to SUNG) or select it with the MAP IN
NOTE parameter (MAP IN SOURCE set to MANUAL).
Now you can change the harmony interval with the
MAP IN NOTE parameter described below.
V1 to V4 MAP OUT
Sets the interval relationship between each of the four
harmony voices for the current input note and key and
scale settings.Typically, incrementing or decrementing any
active harmony voices can make a scale work over your
combination of melody and chord change.
NATURALPLAY = SHIFT Mode
V1 to V4 VOICING
The voicings for Shift mode have no musical intelligence
and as such will produce harmony a fixed, unmoving
interval away from your lead voice. You can select any
semitone interval from -24 semitones to +24 semitones.
They are organized lowest to highest, relative to the
input note.
NATURALPLAY = MIDI NOTES, MIDI
NOTES 4 CHAN Modes
DOUBLING
This changes from an ON/OFF parameter to a selection
of the number of voices you can control via MIDI.
o OFF - No harmony voice doubling is possible but
you have access to 8 unique MIDI note intervals
upon which to build harmonies.
The Edit Menu: HARMONY Tab
70