TC-Helicon VoiceLive 2 User manual - Manual (Page 82)

Overview
This tab contains parameters that don’t pertain to the
other tabs.
LEAD LEVEL
This allows the overall lead (dry with Tone) voice level to
be reduced for the current preset. There are additional
LEAD LEVEL parameters in the effect tabs (uMOD,
DELAY etc) which may be used to reduce lead level
further but only when their respective effect is active.
LEAD PAN
Sets where your lead voice appears in the stereo field for the
current preset.This can be useful when panning a Harmony
voice to one side and your Lead voice to the other.
LEAD EFFECT SENDS
When set to PRE, your voice will be sent at a fixed level
to the μMOD, DELAY and REVERB effects regardless of
whether the LEAD LEVEL setting is reduced or off.
When LEAD LEVEL is off and LEAD EFFECT SENDS is
PRE, 100% wet effects can be achieved if desired. When
set to POST, effect levels follow the LEAD LEVEL value
so the effects stay in balance with your voice when its
level is reduced.
SHORTCUT (Mic Control)
Each preset in VoiceLive 2 can have a unique Shortcut
which can extend your control of effect features. This
parameter will also set the MIC Control target. Choose
from the selections and save to your current preset.
Note that not all may apply e.g. Harmony Hold may not
work unless you have Harmony turned on.
EXPR-PEDAL
Sets the Expression pedal target for the current preset
when GLOBAL EXPR-PEDAL in the Setup tab is set to
OFF (Preset).
HARMONY + DOUBLE LEVEL DELAY + REVERB LEVEL
HARMONY LEVEL
DOUBLE LEVEL
UMOD LEVEL DELAY LEVEL
REVERB LEVEL LEAD LEVEL
μMOD/DLY/REV LEVEL OUTPUT LEVEL
GUITAR LEVEL AUX LEVEL
DELAY SEND LEVEL REVERB SEND LEVEL
RHYTHMIC DEPTH RHYTHMIC DIVISION
The Edit Menu: PRESET Tab
82