TC-Helicon VoiceLive 2 User manual - Manual (Page 22)

First Impressions
22
Activating BYPASS + TUNER Mode
Press and hold the FX footswitch to remove all effects
from your voice except TONE (when active). The Tone
feature remains active in BYPASS + TUNER (Bypass) so
your voice does not sound darker when switching to
Bypass for speaking or singing with no effects.
If you have a guitar connected to the GUITAR IN, its
output will be muted in Bypass and the Tuner display will
become active so you can tune silently.
Tap the FX or any other footswitch to exit Bypass mode
and return to the previous display screen.
Changing The Mix
The effects balance in VoiceLive 2 is adjusted at the
factory to suit many situations. The Mix/Edit knobs
change the levels of :
o the combined Harmony and Doubling voices,
o the combined Delay and Reverb effects
o your guitar and its Guitar FX (as long as GUITAR
THRU jack is unused)
o the overall output level
NOTE: These adjustments are “global” meaning they
affect all presets by the same amount.
With the HOME button lit, turn any of the 4 MIX knobs.
This will present the MIX screen where you can see and
adjust these levels. After approximately 3 seconds the
display will revert back to the HOME screen.Your new
balance will remain in effect each time you power up the
unit until they are changed again.
If you want to adjust the level of a music source
connected to the AUX IN, you can do so with the AUX
LEVEL setting in the SETUP menu under the I/O tab.