TechniSat DIGIT ISIO S2 - Manual (Page 11)

11
5 Initial installation
After you have read the safety instructions and connected the device as described in
section 4, you can then switch it on as described in section 7.
On initial installation of the TV, the AutoInstall installation wizard starts automatically.
The installation wizard allows you to make the most important settings for your digital
receiver in the simplest way possible.
Each step of the installation explains which settings can be made.
> In the installation wizard start window, you can cancel the initial installation by pressing
the red function button. The receiver then begins to run default pre-programming.
In the ensuing installation steps you can press the OK key to accept the preselected
settings and move on to the next step of the installation.
By pressing the Back key, you can go back to the previous installation step, so you
can correct any wrong entries at any time.
The initial installation shown here simply serves as an example.
The exact process for the initial installation will depend on the settings you select. Therefore
please follow all instructions displayed on screen carefully.
Menu language
> When the installation wizard starts, you will first see a window for selecting the
operating language .
> Use the arrow keys to highlight the operating language you want.
The preferred audio language will be set automatically according to this selection.
As described in section 7.4.1, you can change the setting at any time.
> Press the OK button to accept the setting and access the next stage of the installation
wizard.