TechniSat DIGIT ISIO S2 - Manual (Page 28)

28
Some options are selected directly in this window. Other options for a number of
subordinate selection options are located in the options groups. Highlighting one
of these option groups automatically opens a further window on the left.
> You can use the up/down arrow keys within the options group to highlight one of
the options listed there.
By pressing the up/down arrow keys it is possible to move the highlight from line
to line and to move upwards and downwards page by page using the page up/down
buttons.
> The highlighted option is selected by pressing the OK button and you exit the options
selection area.
> If you do not want to select an option or wish to leave the options selection area
without making any changes, simply press the Options button until it is hidden.
7 Operating the unit
7.1 Switching on
> Switch the digital receiver on by pressing the On/Stand-by button either on the
receiver panel or on the remote control.
7.2 Switching off
> Press the On/Stand-by key either on the receiver panel or on the remote control to
switch the receiver off again.
> The receiver is now in ready mode (stand-by). Therefore the time is displayed in the
receiver's display panel (if activated in section 7.2.4).
If the time is not displayed, this still needs to be acquired by the receiver. To do
this, switch the receiver on and set it to receive e.g. ZDF for approx. 30 seconds to
automatically acquire the time.
7.3 Selecting a channel
7.3.1 Using the channel up/down keys
> Use the up/down arrow buttons on the receiver to select a channel, or use the
Channel +/- buttons on the remote control to scroll up or down the channel settings.