TechniSat DIGIT ISIO S2 - Manual (Page 41)

41
Fault Possible cause Solution
Receiver cannot be
operated, switched on or off
Defective data stream -->
receiver blocked
Hold down the On/Stand-by
button on the receiver or the
remote control for approx.
5 seconds.
Disconnect mains plug for
approx. 5 seconds, then
reconnect receiver
Perform Flash-Reset:
Warning!
All personal settings will be
lost.
> Remove mains adapter
from the receiver
> Press and hold
Standby and the up
arrow key on the device
at the same time.
> Reinsert the mains
adapter while Standby
and the up arrow key
are pressed down
> Keep both buttons
pressed down for approx.
5 sec. then release.
“Factory setting"
appears in the display.
USB device not recognised USB device formatted for
wrong file system
Format USB device for
FAT32 file format
Device automatically
switches off after a certain
time
Auto Standby function
enabled
Check Auto Standby setting
and disable if necessary.
(see section 7.2.7)