TechniSat TechniStar S2 - Manual (Page 14)

14
> By pressing green function key Start, an automatic channel scan is run.
In doing so, all selected satellites in the antenna configuration are automatically
scanned for channels. This procedure may take several minutes. Please note all
messages displayed on screen.
If the channel search has been skipped, the default channel list is loaded.
If either Belgium, Netherlands or Luxembourg has been selected in the country
selection, a Fastscan is run according to the programme provider's specifications
instead of the channel search described above.
Software updates
The digital receiver will now check whether a new version of the software is available for
the receiver. If a new software version is available, you can carry out an automatic software
update.
> If you do not want to wait for a search for new software or a software download, you
can skip this step by pressing the yellow function key.
If the search for new software or updates is skipped, your device will run another test
at the time set in the Software update menu and automatically download the
software, as long as this setting is left active and the device is in standby mode at that
time.
> If there is no new TV software available, you can press the OK button to go to the
next step in the installation wizard.
> If, on the other hand, new TV software is found, the automatic software update can be
started by pressing the OK button.