TechniSat TechniStar S2 - Manual (Page 25)

> Confirm by pressing OK.
7.4.4 Calling up blocked channels
If a programme is selected that is blocked by the parental control function, the message
Device PIN will be displayed on the screen.
> Use the numeric keys to enter your PIN code.
The channel you want will be displayed.
or
> Switch to a channel that is not blocked.
If global parental control is enabled, the device PIN code will be requested again when
the blocked channel is switched on. To make things easier for you, you only need
enter the PIN code once during each operating phase.
When doing so pay careful attention to the information and settings for global and
user-dependent parental control (TechniFamily).
7.4.5 Return to last channel selected
> Press the Back button on the remote control to return to the last channel selected.
> Press the button again to return to the channel you were previously watching.
7.4.6 TV/Radio switchover
> You can use the TV/Radio button to switch between TV and radio mode.
The device switches to the last radio station listened to.
7.4.7 Infobox
An Info box appears on the screen for a set period every time you change channels.
This Info box displays the location and name of the selected channel, the title of the current
programme and the currently active channel list.
The progress bars are coloured yellow according to the amount of transmission time
already expired for the current programme. If the beginning of the progress bar is
coloured red, the transmission started too early; if the end of the progress bar is
coloured red, the current programme has post-roll time.
Additional programme properties are also displayed:
For example:
for teletext
for 16:9 broadcasts
for encrypted channels
for Dolby Digital broadcasts
for subtitles
for mono broadcasts
Also, where available from the provider, the EPG genre and the FSK (Voluntary Internal Film
Industry Monitoring) age restriction will be shown.
25