Toa RM-971 - Manual (Page 22)

22
Extinguishes.
Selected key
5. To terminate the Main Rack BGM Broadcast, press the selected key again. The corresponding zone
indicator is extinguished, and the message on the screen also disappears.
Note
• Even if the Broadcast Reset key is pressed during the Main Rack BGM Broadcast, the BGM is continuously
broadcast without being interrupted.
• The Main Rack BGM broadcast function may be disabled depending on the main rack the remote control
unit is connected to. For details, refer to the instruction manual enclosed with the Main Rack EP-0510.
6.3.2. Making the Main Rack BGM Broadcast from the Integrated Remote Control Unit
The Main Rack BGM Broadcast can be made from the Integrated Remote Control Unit as well. To broadcast,
simply press the group or zone selector key set for [BGM] by data writing at the EP-0510 Integrated Control
Panel. Other operations also remain the same as those described in the above section "Making the Main Rack
BGM Broadcast".
Note
The Main Rack BGM broadcast function may be disabled depending on the main rack the remote control unit
is connected to. For details, refer to the instruction manual enclosed with the Main Rack EP-0510.
6.3.3. Equipment that can make the Main Rack BGM Broadcast
Using the EP-0510's internal switch, either the main rack or Integrated Remote Control Unit can be designate
as equipment that can make the Main Rack BGM Broadcast. The system is set by the factory to enable the
broadcast from both units. For the setting contents and method, refer to the section "SETTING OF THE
INTEGRATED CONTROL PANEL EP-0510" in the "Installation Manual - Basic Installation" enclosed with the
EP-0510.
Note
• When unit is not registered as Main Rack BGM Broadcasting Equipment, the group or zone selector key
cannot be used even if it is set for [BGM].
• The Main Rack BGM broadcast function may be disabled depending on the main rack the remote control
unit is connected to. For details, refer to the instruction manual enclosed with the Main Rack EP-0510.
6.4. About the General-Purpose All-Zone Broadcast
Initial status of the general-purpose all-zone broadcast is set for "normal all-zone broadcast" by the factory. If
the "attenuator-free general-purpose all-zone broadcast" is more desirable, which allows announcements to
go through regardless of the speaker attenuator setting, the setting can be changed by data writing. Refer to
the "Installation Manual - Writing" enclosed with the EP-0510 (main rack) for details.