Triner Scale TMU-295 User Manual
Page 54
5-14
Commands
[Notes]
• The DIP switch settings are not checked again.
• The data in the receive buffer is not cleared.
• The macro definition is not cleared.
ESC C n
[Name]
Set cut sheet eject length
[Format]
ASCII
ESC C
n
Hex
1B
43
n
Decimal
27
67
n
[Range]
0
≤
n
≤
127
[Description] Sets the eject length for a cut sheet to n lines.
[Notes]
• When n = 0, no eject length is set.
• The previously specified eject length does not change, even if the
line spacing changes.
• This command is available only when FF is executed.
[Default]
n = 0
[Reference]
FF
ESC D [n] k NUL
[Name]
Set horizontal tab positions
[Format]
ASCII
ESC
D
[n] k NUL
Hex
1B
44
[n] k 00
Decimal
27
68
[n] k 0
[Range]
1
≤
n
≤
255
0
≤
k
≤
32
[Description] Sets horizontal tab positions.
• n specifies the column number for setting a horizontal tab position
from the beginning of the line.
• This command cancels the previous horizontal tab settings.
• n = column number to be set - 1. When setting n = 8, the print
position is moved to column 9 by sending HT.
• k indicates the total number of horizontal tab positions to be set.
• The horizontal tab position is stored as an absolute value of
[character width
✕
n] measured from the beginning of the line. The
character width includes the right-side character spacing, and
double-width characters are set with twice the width of normal
characters. Also, when character is enlarged in the horizontal
direction in page mode, the horizontal position is set as the same
way as in standard mode.
• Transmit [n]k in ascending order and place a NUL code 0 at the
end.
• ESC D NUL cancels all horizontal tab positions. An HT received
after clearing tabs is ignored.