VACUUBRAND MZ 8C - Manual (Page 15)

page 15 of 52
+
Do not use this product in an area where it can fall or
be pulled into water or other liquids.
+
Pay attention to the permissible maximum ambient
and gas inlet temperatures (see „Technical data“, pg.
23).
• Adopt suitable measures in case of differences from
recommended conditions, e.g., using the equipment
outdoors, installation in higher altitudes, conductive
pollution or external condensation on the pump.
• Do not operate this product near flames.
To the best of our knowledge the equipment is in com-
pliance with the requirements of the applicable EC-direc-
tives and harmonized standards (see ”Declaration of Con-
formity”) with regard to design, type and model. Directive
EN 61010-1 gives in detail the conditions under which the
equipment can be operated safely (see also IP degree of
protection, „Technical data“, pg. 23).
Operating conditions
➨
These pumps are not approved for operation in po-
tentially explosive atmospheres. Do not operate the
pumps in potentially explosive atmospheres.
➨
Pumps without the
” ”
mark on the rating plate are
not approved for the pumping of potentially explo-
sive atmospheres. Do not pump potentially explo-
sive atmospheres with those pumps.
➨
Pumps bearing the
” ”
mark on their rating plates
are approved for the pumping of potentially explo-
sive atmospheres according to their classification
II 3G IIC T3 X according to ATEX, but they are not
approved for operation in potentially explosive at-
mospheres (see section „
`
Important information:
Equipment marking (ATEX)“, pg. 21) .
NOTICE