VACUUBRAND MV 2 VARIO - Manual (Page 12)

page 12 of 41
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check
carefully the validity of this document with respect to his product. manual-no.: 999035 / 15/12/2009
Description
General view display
The controller can be adapted to the specific application by choosing another basic
setup than ”TURBO•MODE” (factory-set), see section ”General view basic setups”.
The status of the controller respectively of the connected accessories is displayed by
corresponding symbols on the LCD. After switching on the version of the software is
displayed. Then the basic setup is displayed as well as the symbol “air admittance
valve” (if the valve is preselected) together with ”CAL”. This is displayed until internal
check and adjustment programs are finished (max. five seconds).
Pressure reading
selectable
pressure units
process control
active
warning (in combination
with other symbols)
setups pump symbol air admittance valve remote operation
setup pressure control
or continuous pumping
controller in
TURBO•MODE