Connecting the ipod® or external usb device, Connecting the ipod® or external usb, Device – Ram Trucks 2015 Cargo Van Commercial - Owner Manual User Manual

Page 358

Advertising
background image

Connecting The iPod® Or External USB Device

Use the connection cable to connect an iPod® or external

USB device to the vehicle’s USB connector port which is

located in the glove compartment.

NOTE:

The glove compartment will have a position

where the iPod® or consumer electronic audio device

cable can be routed through without damaging the cable

when closing the lid. This allows routing of the cable

without damaging it while closing the lid. If a cut out is

not available in the glove compartment, route the cable

away from the lid latch and in a place that will allow the

lid to close without damaging the cable.
Once the audio device is connected and synchronized to

the vehicle’s iPod®/USB/MP3 control system (iPod® or

external USB device may take a few minutes to connect),

the audio device starts charging and is ready for use by

pressing radio switches, as described below.
NOTE:

If the audio device battery is completely dis-

charged, it may not communicate with the iPod®/USB/

MP3 control system until a minimum charge is attained.

Leaving the audio device connected to the iPod®/USB/

MP3 control system may charge it to the required level.

USB Port

356 UNDERSTANDING YOUR INSTRUMENT PANEL

Advertising