Straight coping transitions, Print approval, Approval – Flex FLC Coping User Manual
Page 17: Right transition, Left transition, Material, Quantities
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
STRAIGHT COPING TRANSITIONS
NOTE: Indicate slope by circling appropriate outside face.
RIGHT TRANSITION
OUTSIDE
FACE
LEFT TRANSITION
OUTSIDE
FACE
SPECIFY
WALL
SIZE
OUTSIDE
FACE
OUTSIDE
FACE
SPECIFY
WALL
SIZE
□ Standard Leg Lengths
□ Custom Leg Lengths _
□ Standard Leg Lengths
□ Custom Leg Lengths _
NOTES:
- Concealed splice plates are provided with factory
applied dual non-curing sealant strips.
- Unless otherwise noted, fabrication of miters and accessories are
furnished standard utilizing a non-penetrating quicklock joint,
then factory sealed watertight.
Fabrication will proceed only after receipt of
signed print approval.
Print Approval:
Architect and/or contractor shall verify all
dimensions, sizes and quantities. All
products to be installed in strict accordance
with Flex's printed instructions.
Approved by:
____________ ________________
Date:
______________ ______
Welded Miters and Accessories
Check one □ Required (surcharge) □ Not applicable
MATERIAL:
__ 24 Ga. (.65 mm) Steel
__ .040" (1.01 mm) Alum.
__ .050" (1.27 mm) Alum.
Color:
__ .063" (1.60 mm) Alum.
Other
Finish:
QUANTITIES:
Right Transition(s)
Left Transition(s)
PROJECT:
ARCHITECT:
ROOFING CONTRACTOR:
REPRESENTATIVE/DISTRIBUTOR:
Customer Service:
Phone: 800-969-0108
Fax:610-916-9501
DATE: 12/13/10
DRN BY: JJC
CKD BY: SAK
SHT.# OF
DWG# 28011-3472
p; 800-969-0108
f: 610-916-9501
approval
87